美女与野兽免费观看,无码人妻精品一区二区蜜桃网站,久久AV高潮AV无码AV喷吹,免费无码又爽又刺激高潮的APP

產品列表PRODUCTS LIST

首頁 > 技術與支持 > Cryo.STM凍存管使用方法
Cryo.STM凍存管使用方法
點擊次數:2541 更新時間:2022-07-04
Cryo.STM凍存管使用方法

Freezing protocol
冷凍步驟

1. Wash the cells with warm PBS solution, aspirate the solution and cover the cells with a solution containing trypsin and EDTA (a thin liquid film is enough; the concentration should be evaluated for each cell line).
用溫的 PBS 溶液洗滌細胞,吸取溶液,含有胰蛋白酶和 EDTA 的溶液覆蓋細胞(薄薄 的液層足夠了,胰蛋白酶和 EDTA 的濃度需要根據細胞系確定)。
2. Incubate the cells for max. 3 – 5 min at 37 °C.
37℃孵育細胞 3-5 分鐘。
3. Once the cells detach from the bottom, stop incubation by adding cell culture medium supplemented with serum and slightly suspend cells using a pipette.
細胞從底部脫離之后,終止孵育,加入含有血清的培養基,用移液器輕輕地懸浮細胞。
4. Spin down the suspension (500 x g, 5 min) and resuspend the pellet with medium containing serum.
離心細胞懸液(500 x g, 5 分鐘),用含有血清的培養基重新懸浮。
5. Determine the cell number (using a Neubauer chamber).
細胞計數。
6. Spin down the cells for 5 min at 500 x g and discard the supernatant. Resuspend the pellet with an adequate volume of cell culture medium containing serum.
離心細胞懸液(500 x g, 5 分鐘),去除上清液,用適量體積的含有血清的培養基重新 懸浮細胞。
7. Mix the cell suspension 1:1 with freezing medium (60 % medium, 20 % FCS, 20 % DMSO) and transfer it in Cryo.STM. For freezing in Cryo.STM the concentration of cells should be 1 – 5 x 106 cells / ml.
2/4 以 1:1 體積比混合細胞懸液和凍存液(60%培養基,20%胎牛血清,20% DMSO),然 后轉移到 Cryo.STM 凍存管中。凍存的細胞密度為 1-5×106 個/毫升。
8. Cryo.STM containing cells should be frozen at a cooling rate of -1 K / min. This can be achieved by placing them into an isopropanol-filled chamber at -70 °C. If other types of samples are contained, Cryo.s™ may be frozen directly at -20 °C, -70 °C or in the gas phase of liquid nitrogen. In order to assure even freezing of the sample, 4 and 5 ml Cryo.s™ should be frozen at -20 °C overnight before transferring them to -70 °C or to the gas phase of liquid nitrogen.
含有細胞的 Cryo.STM 凍存管建議以-1 K / min 的速率降溫,可以將凍存管置于-70℃含 有異丙醇的容器中。如果Cryo.STM凍存管含有其他樣品,可以直接放置在-20℃,-70℃ 或者液氮的氣相。為了確保樣品冷凍均勻,4 ml 和 5 ml 的 Cryo.STM凍存管需要先置于 在-20℃冰箱過夜,然后再轉移到-70℃或者液氮的氣相。
9. Then transfer the Cryo.STM into the nitrogen tank. To avoid contamination (e. g. mycoplasma) and due to safety precautions it is recommended to store the Cryo.STM in the gas phase above and not in the liquid nitrogen.
然后轉移 Cryo.STM 凍存管到液氮罐。為了避免污染(如支原體)和安全考慮,請將 Cryo.STM 凍存管置于液氮的氣相,切勿置于液相。

Thawing protocol
解凍步驟

1. Immediately after removing them out of the nitrogen tank the frozen cells are thawed in about 1 – 2 min brandishing the Cryo.STM in a water bath at 37 °C. The thawing process should be performed as fast as possible.
從液氮罐取出凍存的細胞后立即置于 37℃水浴搖晃 Cryo.STM 凍存管 1~2 分鐘。解凍 過程需要越快越好。
2. Transfer the thawed cell suspension into a 15 ml tube and mix it immediately with copious amounts of cell culture medium containing serum.
轉移解凍的細胞懸液于 15 mL 離心管,立即用大量的含有血清的細胞培養基混勻。 3/4
3. After spinning down the cells (500 x g, 5 min) discard the supernatant and resuspend the pellet in an appropriate cell culture medium supplemented with serum and transfer it into one or more cell culture flasks.
500 x g離心細胞5 分鐘,去除上清液,用適量的含有血清的細胞培養基重新懸浮細胞, 然后轉移到細胞培養瓶。
4. Follow the recommended cell concentration for seeding.
按照建議的細胞濃度接種。
5. During the next 12 hours cells should rest.
接下來的 12 小時細胞進入靜默期。
6. A change of medium is recommended after 24 resp. 48 hours.
間隔 24 小時和 48 小時更換培養基

Safety advisory for working with Cryo.STM
Cryo.STM凍存管安全操作建議


Cryo.STM tubes are intended for sample storage exclusively in the gas phase over liquid nitrogen or in freezers! If Cryo.STM are stored in the liquid phase, nitrogen can seep into the tubes. Then upon thawing the vaporizing nitrogen can generate high pressure, ultimately resulting in an explosion, as well as the release of any infectious material.
Cryo.STM凍存管用來存儲樣品,只能置于液氮氣相或冰箱。如果 Cryo.STM 凍存管浸沒于液 氮液相,液氮可能滲入凍存管。因此,解凍時,蒸發的液氮產生高壓力,最終導致凍存管炸 裂,并且還將導致感染物質釋放。
Always take appropriate personal safety measures when working with Cryo.STM, including wearing safety clothing, using goggles and working at a safety laboratory bench.
因此,操作 Cryo.STM 凍存管時需要佩戴合適的個人安全防護措施,如穿戴安全防護服、佩 戴護目鏡、在安全櫥操作。
When undertaking cryogenic preservation, Cryo.STM must be evenly exposed to freezing temperatures. Uneven temperature exposures can cause formation of ice plugs (i. e. at tube 4/4 top) that inhibit the expansion of freezing liquid (i. e. at tube bottom), resulting in dangerous high pressure and subsequent harm or damage of tubes.
進行冷凍保存時,Cryo.STM 凍存管需要緩慢地降溫至冷凍溫度。如果不是緩慢地降溫到冷 凍溫度,將導致冰塞形成(如在凍存管頂部),冰塞將阻礙液體形成凝固(如在凍存管頂 部),將導致高壓力危險和后續的爆管風險。
Never exceed maximum working volumes as specified.
不要超過標識的工作體積

我和小娻孑在卧室做了| 国产AV色情成人片在线播APP| 97人人爽人人爽人人人片AV | 少妇扒开腿让我爽了一夜| 国模精品一区二区三区| 国产对白嫖老妇搡老太| 大又大粗又爽又黄少妇毛片| 国产精品久久久久免费A∨| 日本16岁RAPPER| 无码任你躁久久久久久老妇| 老师好大好爽我要喷水了视频| 中国少妇A片BBBBBB洗澡| 欧美重囗味sm群虐视频| 蜜臀AV色欲A片无码精品一区| 欧美极品jizzhd欧美| 少妇风流做爰全过程69| 在线永久看片免费的视频| 欧美熟妇丰满肥白大屁股免费视频| 免费的视频app网站| 人妻被按摩师玩弄到潮喷| 精品国产乱码久久久EA7| 日本护士JZZZZZZZ无码| 100国产精品人妻无码| 欧美虐SM另类残忍视频| 国产AV旡码专区亚洲AV苍井空| 成人精品一区日本无码网站| 久久久久久精品天堂无码中文字幕| 少妇高潮久久久久久| 特黄A级毛片| 成人AV在线观看| 色欲精品久久人妻AV中文字幕| 樱花草视频在线观看免费高清| 欧美亚洲精品SUV| 日本XXXX高清色视频在线播放| 日韩欧美亚洲国产精品字幕久久久 | 国产乱妇无码大片在线观看 | 国产理论片午午伦夜理片2021| 四虎影视永久地址WWW成人 | 好大好湿好硬顶到了好爽视频| 在线二区 中文 无码| 14又嫩又紧水又多|